bigtree-tech Home › Forums › bigtree-tech This forum has 81 topics, 28 replies, and was last updated 1 day, 18 hours ago by agfazio. Viewing 15 topics - 1 through 15 (of 81 total) 1 2 3 4 5 6 → Topic Voices Posts Last Post Ender 3 and SKR Mini E3V2 with Raspberry pi ad Octoprint Started by: agfazio 1 1 1 day, 18 hours ago agfazio Artillery X1 upgrade Started by: dakater 1 1 2 days, 18 hours ago dakater ESP-01S module fails – WiFi no active Started by: tokask 1 1 1 week ago tokask Extrude load runs load but does not finish every thing just sits waiting for it Started by: pcsurgeons 1 1 1 week, 2 days ago pcsurgeons E0 retract forward (opposite direction ) Started by: Anonymous 2 2 1 week, 2 days ago Robert S An Ender 6 and a SKR Mini E3 V2.0 Started by: pascal44 2 2 1 week, 2 days ago Robert S Does SKR E3 Turbo support TFT screens Started by: thesamurai 1 1 1 week, 4 days ago thesamurai TFT to motherboard wiring Started by: thesamurai 1 1 1 week, 4 days ago thesamurai Is there any support from BTT? Started by: thesamurai 1 1 1 week, 4 days ago thesamurai Shorted Hotend? Started by: thehumblepepper@gmail.com 1 1 1 week, 5 days ago thehumblepepper@gmail.com Installing Started by: PenstonA 1 1 1 week, 5 days ago PenstonA Ender 3 Pro TFT35 E3 V3.0 – Firmware question for TFT Started by: stacey@levineclan.net 1 1 1 week, 6 days ago stacey@levineclan.net SKR 1.3 dual z + dual struder Started by: antonio3407 1 1 2 weeks ago antonio3407 EZABL doesn’t work on 1.4Turbo Started by: bell1jl 2 2 2 weeks, 1 day ago ElectroTonic BIGTREETECH SKR Mini E3 V2.0 32Bit Control Board and ARC Started by: KillerDog 1 1 3 weeks ago KillerDog Viewing 15 topics - 1 through 15 (of 81 total) 1 2 3 4 5 6 → You must be logged in to create new topics. Log In Username: Password: Keep me signed in Log In