BIGTREETECH SKR Mini E3 V2.0 32Bit Control Board with TFT35 E3 V3.0 Touch Screen

This topic has 4 replies, 5 voices, and was last updated 2 months ago by Amasdeus.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
December 20, 2020 at 2:15 am #98

DrUnKeN_TiGeR
Participant

I have installed this board and the LCD12864 Mode works fine however the touch screen works but it just says “Printer not attatched” i have tried everything. I have tried every baud rate. i have tried multiple Firmwares. Im at a loss. anyone have any suggestions?

December 29, 2020 at 10:30 pm #109

jdjohnson2854
Participant

Did you ever find an answer to this?

December 30, 2020 at 3:34 am #110

cabinfourus
Participant

STAY AWAY FROM BIGTREETECH PRODUCTS!!!!!!!!!!! I CAN’T GET ANY OF THEIR ADD ONS TO WORK!! EEPROM ERRORS! RELAY BOARD WON’T WORK! NO SUPPORT!!

January 14, 2021 at 5:31 am #136

Rex3900
Participant

I had to set the first serial as 3.
Reloaded firmware and it works.

February 4, 2021 at 2:09 pm #152

Amasdeus
Participant

How can i change the merlin mode to toch ?
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.