BTT 1.3 SKR board with induction probe.

Home › Forums › bigtree-tech › BTT 1.3 SKR board with induction probe.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • January 9, 2021 at 8:31 pm #133
    madcap23
    Participant

    all,

    Sorry if this has been asked about already but I am making a CoreXY printer with a BTT1.3 board and I am trying to use an induction sensor. The sensor is a PNP Normally Open version with Supply Voltage : DC 5V;Current Output : 300mA;Response Frequency : 150Hz

    I know the probe is functional because the LED turns on when it is near metal. However every time I do a M119 on the firmware it shows open no matter what I do.

    Any help would be appreciated.

    Madcap23

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.