BTT Relay V1.2 install

Home › Forums › bigtree-tech › BTT Relay V1.2 install

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 26, 2020 at 6:23 pm #103
    cabinfourus
    Participant

    I am trying to install the BTT Relay v1.2 and a UPS (restore print after power loss) board to my printer. I found the manuals but am not clear if I can run both on the same printer and what changes to make in Marlin. Any ideas or help??

    December 26, 2020 at 6:25 pm #104
    cabinfourus
    Participant

    The documentation is lacking a tutorial of sorts.

    December 30, 2020 at 3:37 am #111
    cabinfourus
    Participant

    JUST AS I FIGURED. NO SUPPORT!! I PURCHASED THE I2C EEPROM AND GUESS WHAT? DOESN’T WORK!!!!!!!!!!!!!!!! I AM SICK AND TIRED OF THIS CRAP THEY CALL QUALITY. MOVING ON TO BIGGER AND BETTER. YOU WILL SUFFER AT THE HANDS OF POOR QUALITY AND NO SUPPORT.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.