- This topic has 0 replies, 1 voice, and was last updated 3 months, 3 weeks ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Recently upgraded my printer to BTT002 board, trying to get tft35 v3.0 to work with it. Installed exp 1 and 2, and TFT cables correctly, but when printer boots, I have a chose between emulation mode or touch mode, but when I rotate knob in any direction display (or maybe printer itself) restarts. Does someone have any advice on my situation?
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.