Custom Gcode on TFT 3.5 v3

Home › Forums › bigtree-tech › Custom Gcode on TFT 3.5 v3

Tagged: 

Viewing 1 post (of 1 total)
  • Author
    Posts
  • October 18, 2020 at 5:51 pm #54
    meltonpieman
    Participant

    The custom GCode examples in the default configuration.h file are all one command long.

    Is it possible to attach a set of commands to a custom label? I want to set up one to select a specific mesh and then do a three point level using myBLTouch.

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.