E3 RRF V1.1 – with riprap return “unknown board: “

Home Forums bigtree-tech E3 RRF V1.1 – with riprap return “unknown board: “

Tagged: ,

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #306
    vbbartlett
    Participant

    I just got my E3 RRF V1.1 board and installed it in the ender 3. Following the youtube installation everything went well until I connected my terminal to the printer. When connected it returns the ‘Unknown board: ‘. Also as I was watching the videos there is always reference to the firmware.bin file and it is not in the repo.

    Any help would be much appreciated!

    #311
    vbbartlett
    Participant

    my board is only supported in 3.3beta…

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.