Ender 3 and SKR Mini E3V2 with Raspberry pi ad Octoprint

Home Forums bigtree-tech Ender 3 and SKR Mini E3V2 with Raspberry pi ad Octoprint

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #192
    agfazio
    Participant

    Why is it needed to cut the red power wire in the USB cable between the Raspberry Pi and the SKR Mini E3V2? Or is there a setting to allow the connection? Using Marlin bugfix 2.0.x firmware.

    Also can the Raspberry Pi be connected to the SKR Mini E3V2 using the GPIO pins and a location on the mainboard to connect in stead of USB?

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.