Error Going Home – Marlin 2.0.7.2 – BTT skr 1.4 – TMC2208 UART

Home Forums bigtree-tech Error Going Home – Marlin 2.0.7.2 – BTT skr 1.4 – TMC2208 UART

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #66
    enano79
    Participant

    Hi to all I have an issue wen try to set home to my printer. I have upgrade to skr 1.4 with TMC2208
    Maiboard BTT skr 1.4
    Drivers BTT TMC2208 UART 3.0
    EndStop Fisical (new and tested before and after install) (inverted mode)
    Description: Sending home “G28” it stop Randomly, and I have to try Again and Again to set home (normally axises X or Z),
    when dont have any error, and all Axises are in home, and start to print. (send the G28 Z0) some times does not touch the EndStop and start printing to high.
    and mayor times I get the Error “Print halted”
    this is a test using ProntFace.

    
    
    <blockquote>

    SENT: G28
    SENT: G92 E0
    SENT: M114
    SENT: M105
    RECV: echo:busy: processing
    RECV: echo:busy: processing
    SENT: M105
    RECV: echo:busy: processing
    RECV: echo:busy: processing
    RECV: echo:busy: processing
    RECV: echo:busy: processing
    SENT: M105
    RECV: echo:busy: processing
    RECV: echo:busy: processing
    RECV: Error: Printer halted. kill() called!

    [ERROR] Error: Printer halted. kill() called!`</blockquote>

    <blockquote>`
    >>> G28 X
    SENT: G28 X
    SENT: M105
    RECV: echo:busy: processing
    RECV: echo:busy: processing
    RECV: Error: Printer halted. kill() called!
    [ERROR] Error: Printer halted. kill() called!`

    when axis Z raise one busy processing and is almost to touch the endstop the possition is a little bit lower than normal.

    >>> G28 Z
    SENT: G28 Z
    SENT: M105
    RECV: echo:busy: processing
    RECV: echo:busy: processing
    RECV: echo:busy: processing
    RECV: X:0.00 Y:0.00 Z:0.00 E:0.00 Count X:0 Y:0 Z:0

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.