H2 Extruder on B1 stops printing after 5 minutes

Home Forums bigtree-tech H2 Extruder on B1 stops printing after 5 minutes

Tagged: ,

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #328
    NastySpill
    Participant

    Hello,
    I’ve just installed an H2 on my B1. All was working fine beforehand, now after adjusting the e0 steps per mm, and restarting I’ve loaded a g-code that worked fine before but the printer halts without any error or warnings at the same spot after about 5 minutes. I’ve tried two other verified g-codes with the same result.
    The printer thinks its still printing as the timer keeps counting and the layer height keeps incrementing.
    Can anyone suggest a way to troubleshoot?

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.