heatbed issue with skr1.4 turbo

Home Forums bigtree-tech heatbed issue with skr1.4 turbo

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #261
    frfioron
    Participant

    Hello
    i’m new here…
    i’m using all at 24v
    i have a mk2a 300×300 heat bed (on the bed they write 400W)
    when the bed temperature reach about 50degree (setting is 60), the green led start flashing and after a couple of second the printer give me an error and i have to reboot.
    i wonder: is it a problem regarding current limitation on the the skr1.4 turbo board for the heatbed connector?
    No problem with the bed if I power it directly from my 24V PSU (it reach 100 degree rapid)
    please help me
    thank you
    Francesco

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.