Installing

Home › Forums › bigtree-tech › Installing

Tagged: 

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 17, 2021 at 2:33 pm #181
    PenstonA
    Participant

    I have a Creality Upgrade Ender 3 Pro V4.2.7 Silent Motherboard with TMC2225 Driver and trying to install a BTT TFT35 E V3.
    Made the boot sc with
    BIGTREE_TFT35_V3.0_E3.26.x.CUR
    config.ini.CUR
    language_en.ini.CUR
    TFT35.CUR

    This loaded OK on TFT

    Making
    EEPROM.DAT
    which is appears to be blank.

    The screen comes up with all the options but is displaying No Printer Attached
    if I move to the emulating screen it works OK

    The black cable, where should that go on the motherboard, and what way round as the is no guide slots

    Thanks

    March 31, 2021 at 2:04 pm #248
    PenstonA
    Participant

    I have the same problem except that i did the update as you did but I am getting an error saying out-of-date data, and can no longer use it in either mode. Did you find out how to install on the silent motherboard

    Thanks

    March 31, 2021 at 3:40 pm #249
    PenstonA
    Participant

    Solved the software problem, I was using an SD card over 8GB, tried again on 128mg card and all worked. Now need to plug it into motrboard

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.