I’ve Just installed the SKR E3 mini V2 with the Tft35 screen and compiled Marlin 2.0.7 and the latest firmware available for the screen.
Everything works well, I can control everything on the printer, motors, autohome, ABL, etc, except that if I print within the touch screen mode it won’t show the printing process properly at the beginning, nor temperature, fan or layer. It will start the printing however, and only after the actual print starts it will only show the temperature after a while, but not when is heating up and if I cancel the print it goes into that loading msg with black screen and I have to restart the printer…. In Marlin mode everything works perfectly, so not sure if I’m missing something here. Any ideas?