Skr mini e3 v2.0

Home Forums bigtree-tech Skr mini e3 v2.0

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #151
    mikes918
    Participant

    Installed new board on ender 5 pro.install went smooth after power up i auto homed and the steppers made a loud noise and will not move either direction.i had a 4.2.2 board iam replacing the only difference i noticed is the steppers are flipped from one board to other there opp of the creality board is this the cause of my problem do i need to flip all the pins around or cut the clips and flip on skr board.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.