SKR Mini v1.1 and TMC2209 v1.2 – Jumper config for UART/SteelGuard

Home › Forums › bigtree-tech › SKR Mini v1.1 and TMC2209 v1.2 – Jumper config for UART/SteelGuard

Viewing 1 post (of 1 total)
  • Author
    Posts
  • December 17, 2020 at 5:21 pm #93
    darkneo
    Participant

    Hello everybody!

    I am planning to upgrade my SKR mini v1.1 with new TMC2209. But I would like to activate the UART & Steelguard functionnalities on it… But I cannot find any configuration to do so on the github page…

    Could some please tell me if I need to set the jumpers somehow? Connect wires from endstops to drivers?

    Thanks a lot for your help!

    131907523_10157283754475146_771316638117818404_o 131907523_10157283754475146_771316638117818404_o
  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.