- This topic has 0 replies, 1 voice, and was last updated 1 week, 2 days ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
I have a problem. When i start printing the nozzle won’t go to the center. It prints only in the bottom left corner of the bed if i put in cura origin to center or if i put the origin to the bottom left corner it goes straight to the right back corner. I would like the full setup for centering the bed printing area. Thanks in advance.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.