- This topic has 0 replies, 1 voice, and was last updated 6 months, 3 weeks ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
I’ve upgraded my tft70 to firmware v3.0.26 and uploaded the round miracle theme.
The unload and load filament buttons do not seem to issue a command to the printer.
They work in the Unified theme but throw up a warning about cold extrusion, it would be better if it brought up the preheat options as it does in marlin mode.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.